Mount Power Distribution Units; Step 2: Connect The Lc 2000R Data Cables To Peripheral Components; Plan Data Connections; Overview Of Lc 2000R Data Connections - HP D5970A - NetServer - LCII Reference Manual
Rack cabling reference guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 3
Mount Power Distribution Units
Plan the location of the Power Distribution Unit or Units (PDU) by reference to
amperage, power, and the number of receptacles. See Chapter 2, the section
entitled "Wide Range PDU Configurations," particularly Table 2-4.
Follow mounting instructions included with your power distribution units. Notice
these cannot be installed behind some equipment. See Table 2-3.
Step 2: Connect the LC 2000r Data Cables to
Peripheral Components
Plan Data Connections
Plan where data connections are to be made and locate cables to be used. There
are hook-and-loop cable ties and also colored pairs of cable markers with labels in
each server package.
Attach data cables to the boards and ports of the server. Use the colored plastic
cable ties to identify both ends of the cable. Support cables with hook-and-loop
cable ties.
Overview of LC 2000r Data Connections
This section shows examples for how to connect data cables between the server
and mass storage units. For more information on such connections, see the
HP Rack Storage/12 Installation Guide or the HP Rack Storage/12FC Installation
Guide.
Figure 3-1, "Overview of Data Cabling of the HP NetServer LC 2000r to the Rack
Storage/12" shows a set-up you might assemble before running HP NetServer
Navigator to configure your server.
See the HP NetServer LC 2000/2000r Installation Guide for more information on
setting up the system.
CAUTION
Cables with thumb-screws should only be snug or finger-tight.
Excessive tightening could damage the mating connector.
Figure 3-1 shows the connections of the mouse, video, and keyboard cables from
the devices through the HP Console Switch, to the server. Alternate cabling paths
for SCSI cables from the server to the mass storage units are also shown.
32
Procedure for Connecting and Routing Cables to the LC 2000r
Advertisement
Table of Contents
