HP D5970A - NetServer - LCII Configuration Manual page 67

Microsoft cluster for server with hp a3661b model 30/fc high availability disk array

Hide thumbs Also See for D5970A - NetServer - LCII:

Table of Contents

3. Mount the HP FC-AL Hub into the Cabinet

The HP FC-AL hub mounts into the HP E3662A or E3662B 2.0m high, 19-inch wide, 220VAC, EIA cabinet (also called

a rack). The following procedure describes mounting an HP FC-AL hub with its front panel facing the rear of the

cabinet. The front of the HP FC-AL hub contains the 10 Fibre Channel connectors.

Record the serial number, located on the bottom of the HP FC-AL hub, before installing the HP FC-AL hub into the

cabinet.

Power down the cabinet and unplug it from the power source. Refer to the cabinet documentation for more

information. Make sure the cabinet is adequately secured and has enough space (1 EIA) for the HP FC-AL hub.

Remove filler panels as needed from the front of the cabinet and open the rear door.

Slide a sheet metal nut onto the outer column in the back of the cabinet, so the hole in the nut is aligned with the

hole at the selected EIA location on the column.

Insert one end of the left rail in the adjoining slot, so the hole in the rail lines up with the holes in the nut and column

(see figure 6).

Attach the other end of the rail to the inner column on the front of the cabinet using the same procedure and a second

sheet metal nut.

NOTE

Repeat steps c, d, and e to install the right rail.

Do NOT attach screws at this time.

Figure 6. Installing rails for the FC-AL hub into the cabinet

Table of Contents

Chapters

Table of Contents