HP D5970A - NetServer - LCII Installation And User Manual page 61
Hp netserver fcarray assistant - installation and user guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- User manual (147 pages)
Table of Contents
Advertisement
Chapter 4
Enable Vendor Unique Test Unit Ready Status - Enables a vendor
unique TUR effect. A TUR sent to an offline LUN will get a hard error
status returned.
Enable No Pause on Controller Not Ready - When the controller is not
fully started, certain commands encounter a pause. This turns off the pause.
Enable Auto Restore - Allows the surviving controller to automatically
sense and place an inserted replacement controller back in service.
Controller Present/Fault Signals must be enabled.
Enable Force Simplex - Allows duplex firmware to work in a simplex
environment by skipping some Active-Active operations.
NOTE
This parameter must be set for each FCArray Controller in the
system. Force Simplex must be checked (enabled) for Simplex
Controller operation. For Dual-Active Controller operation,
Force Simplex must be unchecked (disabled).
Enable Reset Propagation - Allows a port that executes an internal reset
to cause a reset event to occur on its attached interface.
Enable Multi-port Reset - Allows execution of an internal reset on a port
only if a logical drive has been reserved through that port.
Set this option by Disabling (checking) or Enabling (un-checking) the option.
Disable CC for Invalid LUN - Disables the check condition, affecting the
handling of the Inquiry command when the referenced LUN is invalid.
Choose a setting after Enabling (checking) or Disabling (un-checking) the
following options.
Host Bus Reset Delay (setting) - Allows the controller to reset the host in
failover and failback situations. When disabled, no SCSI bus reset is
generated on the host; 1 - 14 - generates reset this many seconds after the
failover or failback occurs; 15 - generates immediate reset with no delay.
This is host SCSI only.
Debug Port Usage (setting) - Select SLP/VT100 emulation or Debug
mode.
Debug Port Speed (setting) - Sets the baud rate for the debug port.
Choices are from 2400 to 19200 baud.
Configuration
55
Advertisement
Table of Contents
