Disassembly Order; Cable Lock (Optional) - HP Z400 - Workstation Maintenance And Service Manual
Hp z400 workstation maintenance and service guide
Hide thumbs
Also See for Z400 - Workstation:
- Maintenance and service manual (254 pages) ,
- Quickspecs (63 pages) ,
- Installation manual (10 pages)
Table of Contents
Advertisement
Disassembly order
For convenience, disassembly procedures should be followed in a particular order. Use the following
table to determine the sequence in which to access major workstation components.
Table 5-4
To install/replace...
Hard drive, battery,
front bezel, rear
system fan, side
access panel sensor,
or solenoid lock
Memory, liquid cooling
system, heatsink, or
power supply
Processor
Expansion card (PCI/
PCIe)
Front panel I/O
assembly, power
button assembly, or
system speaker
Optical bay filler or
optical drive
System board
NOTE:
Z400s with 4 DIMM slots do not have an airflow guide.
Cable lock (optional)
If a cable lock is installed on the workstation, remove it before servicing the workstation.
70
Chapter 5 Replacing components
Workstation component installation
Remove...
Then
remove...
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Then
Then
remove...
remove...
Airflow guide
Airflow guide Heatsink
Expansion
Expansion
card support
card hold
down clamp
or support
Front bezel
Airflow guide Front bezel
Airflow guide Expansion
card hold
down clamp
or support
Then
Then
remove...
remove...
Expansion
Liquid
cards or
cooling
DIMMs
system (If
any)
Then
remove...
Heatsink
(optional)
ENWW
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
