HP Xw4600 - Workstation - 2 GB RAM Installation Manual page 5

Sata/sas hard drive and solid state drive

Hide thumbs Also See for Xw4600 - Workstation - 2 GB RAM:

Table of Contents

Remove the drive carrier from the highest empty internal hard drive bay:

Open the handle at the green touch-point (1).

Slide the hard drive carrier out of the bay (2).

Figure 3

Install the hard drive in the carrier:

Position the carrier with the handle end down.

Position the hard drive with the connectors on the back of the drive facing upward.

Separate the rails at (1), carefully seating the pins in the small holes on the drive.

Separate the rails at the top (2).

Pivot the drive into the carrier (3), and snap the pins on the rails securely into the drive.

Figure 4

ENWW

Removing the hard drive carrier from an HP Z800 Workstation

Attaching the hard drive to the drive carrier

Step 2—Preparing and installing the hard drive

Table of Contents