To Exit Hp Netraid Express Tools; Run Other Utilities, If Necessary - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual
Hp netraid 1m/2m installation & configuration
Hide thumbs
Also See for P3410A - NetRAID 1M RAID Controller:
- Read this first (5 pages) ,
- User manual (161 pages)
Table of Contents
Advertisement
Chapter 6
5. To change the SCSI transfer rate:
Choose SCSI Transfer Rate from the SCSI Channel menu. A
submenu appears.
Use the arrow keys to highlight your selection: Fast, Ultra, Ultra2, or
Ultra3. Press Enter.
Choose Yes to confirm your selection.
6. Press Esc to return to the Tools Management menu.
To Exit HP NetRAID Express Tools
To exit HP NetRAID Express Tools, press Esc repeatedly until the Exit? prompt
is displayed. Choose Yes. Then press any key to reboot. The new parameters
become effective after you reboot.
Run Other Utilities, If Necessary
You may need to enable or disable ports or change settings such as IRQs or MP
specifications. To do so, run the utility appropriate for your system, such as:
Setup Utility
EISA Configuration Utility (ECU)
Refer to your HP Netserver documentation for instructions.
HP NetRAID Software
77
Advertisement
Table of Contents
Troubleshooting
