System Configuration menu
NOTE:
Some of the listed System Configuration options may not be supported by your computer.
Select
Language
Boot Options
Device Configurations
To do this
Change the Computer Setup language.
●
Set a Startup Menu delay (in seconds).
●
Enable/disable Custom Logo (disabled by default).
●
Enable/disable CD-ROM boot (enabled by default).
●
Enable/disable SD Card boot (enabled by default).
●
Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (enabled by
default).
●
Set the Express Boot Popup Delay in seconds.
●
Set the boot order.
●
Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
◦
Use of a USB mouse or keyboard in Computer Setup
even when a Windows® operating system is not
running.
◦
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
●
Enable/disable fan always on while connected to an AC
outlet (enabled by default).
●
Enable/disable Data Execution Prevention. When
enabled, the processor can disable some virus code
execution, which helps to improve computer security
(enabled by default).
●
SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦
AHCI (Advanced Host Controller Interface)
◦
IDE (Integrated Drive Electronics)
◦
RAID (select models only)
NOTE:
Availability of the options above varies by
computer model.
●
Enable/disable HP QuickLook 2 (enabled by default).
●
Enable/disable Virtualization Technology (disabled by
default).
System Configuration menu
9