Example Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configuring a 24-Port 8-Gbps Fibre Channel Switching Module Example
These steps describe how to configure the 24-port 8-Gbps module interfaces:
Select interfaces fc 3/1.
Step 1
switch# config t
switch(config)# interface fc 3/1
Step 2
Configure the port speed, rate mode, and port mode on the interfaces.
switch(config-if)# switchport speed 8000
switch(config-if)# switchport rate-mode dedicated
switch(config-if)# switchport mode f
Enable the interfaces and return to configuration mode.
Step 3
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Select the interfaces fc 3/2 through fc 3/3.
Step 4
switch# config t
switch(config)# interface fc 3/2 - 3
Configure the port speed, rate mode, and port mode on the interfaces.
Step 5
switch(config-if)# switchport speed 8000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Enable the interfaces and return to configuration mode.
Step 6
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Configuring a 4/44-Port 8-Gbps Fibre Channel Switching Module Example
These steps describe how to configure the 4/44-port 8-Gbps module interfaces:
Select interfaces fc 4/11 through fc 4/12.
Step 1
switch# config t
switch(config)# interface fc 4/11 - 12
Step 2
Disable the interfaces and take them out of service.
switch(config-if)# shutdown
switch(config-if)# out-of-service
Return to configuration mode.
Step 3
switch(config-if)# exit
switch#
Select the interfaces fc 4/1.
Step 4
Cisco MDS 9000 Family CLI Configuration Guide
15-52
Chapter 15
Configuring Generation 2 and Generation 3 Switching Modules
OL-18084-01, Cisco MDS NX-OS Release 4.x