Paper Details - Canon imagePROGRAF iPF6100 User Manual
Large format printer
Hide thumbs
Also See for imagePROGRAF iPF6100:
- Service manual (692 pages) ,
- Brochure & specs (8 pages) ,
- Troubleshooting manual (191 pages)
Table of Contents
Advertisement
Paper Details
Setting Item
(The paper type is
displayed here.)(*1)
Roll DryingTime
Specify the time to wait for the ink to dry for each sheet.
Scan Wait Time
Specify the time to wait for the ink to dry between each scan
in bidirectional printing, in consideration of how quickly the
ink dries. Note that printing will take longer if you specify a
wait time.
Feed Priority
Specify exact paper feeding, if desired. Normally, select
Automatic. Choose Print Length if you prefer to feed
the paper an exact amount. However, note that choosing
Print Length may result in slight banding in the direction of
Carriage scanning.
Adjust Length
Displayed if Feed Priority is Print Length.
Adjustment relative to the amount of stretching or shrinkage
of the current paper.
Enter either the adjustment results from Print Pattern or the
discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends
to shrink, decrease the feed amount by choosing a lower
adjustment value.
Head Height
Adjust the Printhead height. (→P.588)
Skew Check Lv.
If you print on Japanese paper (washi) or other handmade
paper that has an irregular width, choose Loose for a higher
skew detection threshold, or choose Off to disable skew
detection. However, if paper is loaded askew when detection
is Off, note that paper jams or Platen soiling may occur.
VacuumStrngth
Specify the level of suction that holds paper against the Platen
. (→P.595)
NearEnd RollMrgn
Specify the minimum margin at the leading edge of roll paper
to ensure better printing quality at the leading edge.
Note that if you choose 3mm , it may lower the printing quality
at the leading edge and affect feeding accuracy. The printed
surface may be scratched, and ink may adhere to the leading
edge. It may also cause the Platen to become soiled.
Cut Speed
Choose the cutting speed. If you use adhesive paper,
choosing Slow helps prevent adhesive from sticking to the
cutter and keeps the cutter sharp.
Trim Edge First
If a roll is loaded, the end of the paper will be cut.
Choose On to have 40 mm (1.6 in) cut off the leading edge of
the roll after you load the roll. Scraps are then removed.
When Automatic is selected, if the left and right side of
the leading edge of the roll are uneven (by 3 mm [0.12 in]
or more), the edge is cut an amount relative to the slant to
ensure a straight edge after you load the roll. Scraps are then
removed.
If the unevenness is less than 3 mm or if Off is selected, the
edge is not cut and scraps are not removed.
Description, Instructions
Control Panel
Printer Parts 51
- Quick Links:
- Replacing the Printhead
Hide quick links:
Advertisement
Chapters
Table of Contents
