Dryer Installation - Kenmore 7965 - 600 5.9 cu. Ft. Capacity Gas Flatback Dryer Installation Manual
Pedestal kit for washer, dryer
Hide thumbs
Also See for 7965 - 600 5.9 cu. Ft. Capacity Gas Flatback Dryer:
- Use & care manual (24 pages) ,
- Installation instructions manual (24 pages)
Advertisement
Available languages
Available languages
DRYER INSTALLATION
(See page 3 for washer instructions.)
O
Insert the T-clip of the 4 retainers into the dryer base
as shown. Press up on the back of the clip and pull
outward to lock into I)lace.
O
Position dryer on top of the pedestal.
NOTE: Because of the weight of the dryer, two or more
people may be needed.
['_-...
f_orr
dWryShr
er
for washer
O
Make sure the holes on the pedestal align with the
holes in the appliance,
then install 4 screws at each
corner to securely attach the appliance
to the
pedestal.
NOTE: If the screws are not installed properly, noise
and vibration ma_ result.
i
J
Q
Move the dryer to the desired location.
NOTE: The appliance and pedestal assembly must be
placed on a solid and level floor for proper operation.
Adjust the legs of the pedestal using the wrench
supplied. Tighten the lock nuts with the wrench.
Lock nut
Adjustable
feet
NOTE: If dryer was previously installed, uninstall it as
follows:
A.
Uninstalling
an electric
dryer:
1) Unplug the power supply cord,
2) Pull the dryer away from the wall enough to loosen
the vent clamp, Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet,
B.
Uninstalling
a gas
dryer:
1) Unplug power supply cord.
2) Turn off the gas supply.
3) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.
4
Advertisement
