HP 4400 Replacement Instructions page 3
Fibre channel and sas disk drive
Hide thumbs
Also See for 4400:
- Software manual (77 pages) ,
- Release note (48 pages) ,
- Quickspecs (31 pages)
Advertisement
1. Locate/Fault
Figure 6 FC disk status indicators
.
1. Locate/Fault
Figure 7 SAS disk status indicators
.
Table 1 Disk status indicator LED descriptions
LED
LED Color
Blue
1. Locate/Fault
Amber
2. Status
Green
Check the disk status using HP P6000 Command View:
1.
In the Navigation pane, select Storage system > Hardware >
Disk enclosure > Bay. Use the information from the error message
to guide you to the correct disk.
2.
In the Content pane, select the Disk Drive tab.
2. Status
2. Status
LED Status
Description
Slow blinking
Locate drive
(0.5 Hz)
Solid
Drive fault
Drive is spin-
Blinking (1
ning up or
Hz)
down and is
not ready
Fast blinking
Drive activity
(4 Hz)
Ready for
Solid
activity
3.
Check the disk Node World Wide Name against the error
message UUID information recorded earlier to ensure you have
selected the correct disk
Figure 8 Checking Node World Wide Name
.
4.
Check the disk operational state. If a hard failure has occurred,
the operational state should be
impending failure indicates Good status until the condition of
the disk degrades enough to become a hard failure.
5.
Verify that the Requested usage and Actual usage boxes display
Ungrouped
(Figure
Figure 9 Checking disk group status
.
CAUTION:
Both fields must display Ungrouped before you
remove the disk.
If fields display Ungrouped, continue with
ungroup the disk, continue with the following step.
Page 3
(Figure
8).
(Failed). A disk with an
9).
Step
7. If you must
Advertisement
