Removing A Processor - Dell 8 Owner's Manual
Poweredge modular systems
Hide thumbs
Also See for 8:
- Command reference manual (302 pages) ,
- Update manual (186 pages) ,
- Getting started manual (172 pages)
Table of Contents
Advertisement
PowerEdge M805 System
•
The PowerEdge M805 system supports dual-core or quad-core AMD
Opteron 2xxxx series processors only.
•
Two processors must be installed; single-processor configurations are not
supported.
•
Hypertransport (HT) bridge cards must be installed in sockets CPU3 and
CPU4. See "HT Bridge Card (PowerEdge M905 Only)" on page 242.
PowerEdge M710, M710HD, M610, M610x, and M600 Systems
•
The PowerEdge M710, M710HD, M610, M610x, and M600 systems
support dual-core, quad-core, or six-core Intel
•
Both single and dual-processor configurations are supported.
PowerEdge M605 System
•
The PowerEdge M605 system supports dual-core or quad-core AMD
Opteron 2xxxx MP series processors only.
•
Both single and dual-processor configurations are supported.
Removing a Processor
1 Remove the blade. See "Removing a Blade" on page 145.
2 Open the blade. See "Opening the Blade" on page 149.
WARNING:
processor has had sufficient time to cool before handling.
NOTE:
Never remove the heat sink from a processor unless you intend to remove
the processor. The heat sink is necessary to maintain proper thermal conditions.
3 Loosen the screws that secure the heat sink to the system board. See the
appropriate illustration for your blade.
226
Installing Blade Components
The processor and heat sink can become extremely hot. Be sure the
®
®
Xeon
processors only.
- Quick Links:
- I/O Connectivity
- Troubleshooting Hard Drives
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
