Vlan Commands; Interface Vlan - Dell 8 Command Reference Manual
Dell converged enhanced ethernet command reference
Hide thumbs
Also See for 8:
- Owner's manual (346 pages) ,
- Update manual (186 pages) ,
- Getting started manual (172 pages)
Table of Contents
Advertisement
VLAN Commands
interface vlan
Configures a VLAN interface.
Synopsis
interface vlan vlan_id
no interface vlan vlan_id
Operands
vlan_id
Defaults
VLAN 1 is predefined on the switch.
Command
Global configuration mode
Modes
Description
Use this command to configure a VLAN interface. Use the no interface vlan vlan_id command to
delete a VLAN interface.
Usage
All of the ports on the switch are a part of the default VLAN 4095.
Guidelines
Make sure your converged mode interface is not configured to classify untagged packets to the
same VLAN as the incoming VLAN-tagged packets. By configuring a converged interface to classify
untagged packets (by using classifiers or the default port vlan_id) to the same VLAN as
VLAN-tagged packets coming into the interface, the FCoE hardware sends out untagged packets to
the CNA. These packets may be dropped, disrupting communications.
Examples
To create a VLAN with ID 56:
See Also
interface switchport, fcf forward, shutdown
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the VLAN interface to configure. The range of valid values is from 1
through 3583.
switch(config)#interface vlan 56
switch-cmsh(conf-if-vl-56)#
Chapter
3
47
Advertisement
Table of Contents
