Factory Connected Power Supply Cord (Canada Only); Power Supply Cord Kit (U.s.a.); Electrical Shock Hazard - Electrolux E30DF74GPS - 30" Pro-Style Dual-Fuel Range Instalation Instructions
30" & 36" dual fuel range
Hide thumbs
Also See for E30DF74GPS - 30" Pro-Style Dual-Fuel Range:
- Use and care manual (37 pages) ,
- Wiring diagram (1 page)
Table of Contents
Advertisement
Available languages
Available languages
30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
2.
Factory Connected Power
Supply Cord (Canada only)
Your range is equipped with a factory-connected power
cord (see Figure 3). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician.
3.
Junction Box or Wall
Receptacle Location
Suggested location of the junction box or wall
receptacle is showed in Figure 4 for 30" Range and
on figure 5 for 36" Range. It can also be located
in the lower left cor ner of the adjacent right
cabinet (see Figure 6). If a service cord is used, the
wall receptacle should be located in accordance with the
dimensions below.
4.
Power Supply Cord Kit (U.S.A.)
The user is responsible for connecting the power supply
cord to the connection block located behind the back
panel access cover.
This appliance may be connected by means of
permanent "hard wiring" (flexible armored or
nonmetallic shielded copper cable), or by means of a
power supply cord kit. Use only a power supply cord kit
rated at 125/250 volts minimum and marked for use
with ranges. Cord must have either 3 or 4 conductors.
Terminals on end of wires must either be closed loop or
open-end spade lugs with upturned ends. Cord must
have strain relief clamp.
A 3-wire* or 4-wire single phase 120/240 or 120/208
Volt, 60 Hz AC only electrical supply is required on a
separate circuit fused on both sides of the line (time-delay
fuse or circuit breaker is recommended). DO NOT fuse
neutral. The fuse size must not exceed the circuit rating of
the appliance specified on the nameplate.
For 30" or 36" Range: Use a power supply cord kit
rated at 30A.
* For mobile homes, new installations, recreational
vehicles, or areas where local codes do not permit
grounding through neutral, a 4 conductor power
supply cord kit rated at 125/250 volts and marked for
use with ranges should be used (see Figure 10).
(Model with Electric Oven and Gas Cooktop)
Figure 3
(25.4 cm)
7" Max.
(17.8 cm Max.)
Locate Electrical Hook-up
Inside Shaded Area
30" Range Junction Box or Wall
Receptacle Location - Figure 4
W A L L
36" Range Junction Box or Wall
Receptacle Location - Figure 5
Electrical Shock Hazard
• Electrical ground is required on this appliance.
• Do not connect to the electrical supply until
appliance is permanently grounded.
• Disconnect power to the circuit breaker or fuse
box before making the electrical connection.
• This appliance must be connected to a
grounded, metallic, permanent wiring system,
or a grounding connector should be connected
to the grounding terminal or wire lead on the
appliance.
• Do not use the gas supply line for grounding
the appliance.
Failure to do any of the above could result in a
fire, personal injury or electrical shock.
4
Center
Line of
Range
10"
W A L L
Center
Line of
Range
Center
Line of
Range
10"
(25.4 cm)
5" Max.
2.7
(1
cm Max.)
Locate Electrical Hook-up
Inside Shaded Area
Center
Line of
Range
8"
(20.3 cm)
12"
(30.5 cm)
Figure 6
Advertisement
Table of Contents
