D-Link DCS-1000W Manual page 21

2.4ghz wireless internet camera

Hide thumbs Also See for DCS-1000W:

Table of Contents

Loading ActiveX From:

This field is used to specify the location of Xplug Control (ActiveX) plug-in

program. Enter the information as required in .ocx format, for example:

http://www.<your company>.com/xplug.ocx where <your company> must be

replaced with your company's DNS server.

Instructions for installing ActiveX from the driver CD is included in this

manual. Refer to the section labeled "Software Installation".

Open Second Port:

The Web Server field allows settings to open a second port for the DCS-

1000W. This will permit users of IP Sharing Gateways to support multiple

DCS-1000Ws. By default Port 80 is always opened for DCS-1000W Web

Server access. Select "Yes" and input the second port value.

For example: If you have 5 Internet Cameras to be installed, each with an IP

address from

192.168.0.101

192.168.0.102

192.168.0.103

192.168.0.104

192.168.0.105

You can open the second port for each Internet Camera from port 81 to Port

85 as illustrated below:

DCS-1000W 1 – IP 192.168.0.101, second web port 81

DCS-1000W 2 – IP 192.168.0.102, second web port 82

DCS-1000W 3 – IP 192.168.0.103, second web port 83

DCS-1000W 4 – IP 192.168.0.104, second web port 84

DCS-1000W 5 – IP 192.168.0.105, second web port 85

You also need to setup your DSL gateway for Port Mapping.

Port 81 map to 192.168.0.101

Port 82 map to 192.168.0.102

Port 83 map to 192.168.0.103

Port 84 map to 192.168.0.104

Port 85 map to 192.168.0.105

Table of Contents