Subnet Mask
Enable DHCP Server on the LAN
Start IP Address
End IP Address
Lease Time
Configure the second IP Address and Subnet Mask for LAN interface
IP Address
Subnet Mask
2. Click
to make these parameters effective.
6.3
NAT
Click the sub-menu "NAT" of "Advanced Setup", you may start to configure the NAT features
below:
1. Virtual Server: You may click
and related Protocol, external/internal port and Internal server IP address (Figure 6.8 and 6.9).
Click
to make these parameters effective.
The LAN subnet mask identifies which parts of the LAN
IP Address refer to your network as a whole and which
parts refer specifically to nodes on the network. Your
device is pre-configured with a default subnet mask of
255.255.255.0.
The lowest IP addresses in the DHCP address pool.
The highest IP addresses in the DHCP address pool.
The amount of time the assigned address will be used by
a device connected on the LAN.
The second LAN IP address of AAM6000EV-M.
The second LAN subnet mask identifies which parts of
the LAN IP Address refer to your network as a whole and
which parts refer specifically to nodes on the network.
Figure 6.7 LAN Setup
to select proper service names, like Telnet, FTP & Web etc.,
AAM6010EV-M ADSL Combo Router User's Manual