Table of Contents
Advertisement
Service and Adjustment
(cont'd)
17. Fold the insulation back in place so that it completely covers
the thermostat and element.
Drain Valve Washer
Replacement
NOTE: For replacement, use a '_2" x *_/_"x V," thick washer
available at your nearest hardware store. For ordering a
replacement washer, refer to the "Parts Order List" section.
18. Replace access panel.
19. Turn "ON" electric power to water heater.
• Before beginning turn "OFF" the electrical power supply to
the water heater.
I
AWARNING
"_
HAZARD OF ELECTRICAL SHOCK! Before removing I
any access panels or servicing the water beater, make R
sure the electrical supply to the water beater is turned I
"OFF". Failure to do this could result in DEATH, SERIoI
OUS BODILY INJURY,OR PROPERTY DAMAGE.
]
• Follow
_Draining"
instructions
in the "Service
and
Adjustment" section.
• Turning counter clockwise, remove the hex cap below the
screw handle.
• Remove the washer and put the new one in place.
• Screw the handle and cap assembly back into the drain valve
and retighten using a wrench. DO NOT OVER TIGHTEN.
• Follow
Fdhng the Water Heater
instructions
in the
Installauon Instrucuons
sectmn.
• Check for leaks.
• Turn "ON" electric power to the water heater.
!AND
Service
Before calling for repair service, read the Start Up Conditions
and Operational
Conditions
found
in the Troubleshooting
Guide of this manual.
If a condition
persists or you are uncertain
about the operation
of the water heater, let a qualified person check it out.
Contact
SEARS Repair Services
at 1-800-4-MY-HOME
(1-800-469-4663)
17
Hide quick links:
Advertisement
Table of Contents
