Table of Contents
Advertisement
Initial IP configuration
Initially the DKVM-IP1 switch network interface is configured with the parameters shown in Table 1-1.
If this initial configuration doesn't meet your local requirements, you need to do the initial IP
configuration. Use one of the following ways:
1. Connect the enclosed NULL modem cable to the serial interface on the rear side. The serial
interface needs to be adjusted with the parameters shown in table 1-2:
Use a terminal software (e.g. hyper term or minicom) to connect to DKVM-IP1 switch. Reset
DKVM-IP1 switch and immediately press < ESC >. You will see some device information and a '=>'
prompt. Enter the command 'config' and press < Enter >. After waiting a few moments you may
configure IP auto configuration, IP address, net mask and default gateway. Pressing < Enter >
without entering values does not change settings. The gateway value must be set to 0.0.0.0 (for no
gateway) or any other value. You will be asked if the values are correct and get a chance to correct
them. After confirming, DKVM-IP1 switch performs a reset.
2. Use a crossover Ethernet cable to connect DKVM-IP1 switch to a subnet where a DHCP server is
available. After the DHCP server has assigned an IP address to DKVM-IP1 switch you can use the
web interface to configure the device.
Web interface
DKVM-IP1 switch may be accessed using a standard JAVA enabled web browser. You may use the
HTTP protocol or a secure encrypted connection via HTTPS. Just enter the configured IP address of
DKVM-IP1 switch into your web browser.
Parameter
IP auto configuration
IP-Address
Net-mask
Default-Gateway
Table 1-1: Initial configuration
Parameter
Bits/second
Data bits
Parity
Stop bits
Flow Control
Table 1-2: Serial parameters
Login name
admin (factory default)
Password
admin (factory default)
Value
DHCP
192.168.0.70
255.255.255.0
none
Value
115200
8
No
1
None
2
- Quick Links:
- Unit Reset
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
