Table of Contents
Advertisement
4.
Getting Started
With its default settings, the DWL-510, when activated,
will automatically connect with other D-Link Air
There are basically two modes of networking:
Infrastructure –
Ad-Hoc –
On the following pages we will show you an example of an Infrastructure
Network and an Ad-Hoc Network.
An Infrastructure network contains an Access Point. The Infrastructure
Network example shown on the following page contains the following D-Link
network devices:
A wireless Broadband Router – i.e., D-Link AirPlus DI-614+
A computer with a wireless network adapter –
i.e., D-Link Air DWL-510
A desktop computer with an Ethernet adapter – i.e., (D-Link DFE-530TX+)
A Cable modem – i.e., D-Link DCM-200
DHCP stands for Dynamic Host Configuration Protocol. It is a protocol
for assigning IP addresses "automatically."
gateway/router, there is no need to manually assign an IP address.
Please refer to the following sections of this manual for additional information
about setting up a network:
Networking Basics- learn how to check and assign your IP Address; share
printers and files.
Using the Configuration Utility- learn the settings for the DWL-510, using
the Configuration Program Utility.
Troubleshooting – learn how to check for common installation issues and
other tips for troubleshooting.
or AirPlus products, right out of the box.
using an Access Point, such as the DWL-6000AP
directly connecting to another computer, for peer-to-peer
communication, using wireless network adapters on each
computer, such as two or more DWL-510 PCI adapters.
With a DHCP-capable
10
Advertisement
Table of Contents
