Advertisement
If the battery terminals are corroded or dirty clean them before attaching the power clamps.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT dis-assemble the charger for any reason. The charger must only be checked by qualified service personnel.
8
DO NOT try to charge a non-rechargeable battery.
8
DO NOT try to charge battery if battery fluid is frozen.
8
WARNING! To prevent the risk of sparking, short circuit and possible explosion DO NOT drop metal tools in the battery area, or
‰
allow them to touch the battery terminals.
DO NOT allow power clamps to touch each other or to make contact with any metallic part of the vehicle.
8
DO NOT cross connect power leads from charger to battery. Ensure positive (+/RED) is to positive and negative (-/BLACK) is to
8
negative.
DO NOT pull the cables or clamps from the battery terminals.
8
DO NOT use the charger outdoors, or in damp, or wet locations and DO NOT operate within the vicinity of flammable liquids or
8
gases.
DO NOT use charger inside vehicle or inside engine compartment.
8
Ensure there is effective ventilation to prevent a build-up of explosive gases, and DO NOT cover or obstruct charger ventilation
9
louvres.
DO NOT use the charger for a task for which it is not designed.
8
WARNING! DO NOT simultaneously charge batteries of different capacities or discharge levels.
‰
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating. Use only Sealey genuine parts.
‰
When not in use, store the charger carefully in a safe, dry, childproof location.
9
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire
9
and electric shock. If an extension cord must be used, make sure:
• That the pins on the plug of the extension cord are the same number, size and shape as those of the plug on the charger.
• That the extension cord is properly wired and in good electrical condition.
• That the wire size is large enough for the AC ampere rating of the charger as specified.
To reduce the risk of electric shock, unplug the charger from the outlet before attempting any maintenance or cleaning. Simply
9
turning off the controls will not reduce this risk.
A marine (boat) battery must be removed and charged on shore. To charge it on-board requires equipment specially designed for
9
marine use.
CAUTION: Only allow children at least 8 years old to use the battery charger. Give sufficient instruction so that the child is able to
use the battery charger in a safe way and explain that it is not a toy and must not be played with.
Instruct the child not to try and recharge non-rechargeable batteries because of the risk of eruption.
Examine the battery charger regularly for damage, it must not be used until it has been repaired.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning an
user maintenance shall not be made by children without supervision.
2.
INTRODUCTION
Fully automatic 7-stage battery charger, designed for trickle charging and maintaining a variety of EFB and AGM (stop/start),
GEL, lead acid and lithium batteries with auto chemistry selection. Zero volt battery charging, enabling recovery and charging of
a completely discharged battery (providing any load removed from the rechargeable battery). Old battery sulfation repair function.
Reverse polarity, short circuit, over temperature and overcharging protection. Intuitive LED screen displays illuminated charging
stages, volts and amps output and battery capacity. Compact design with unique retractable hanging hook, and cable management
system which allows the clips to be stored neatly away when not in use. 13.5V DC power supply mode for battery support during
prolonged electrical and diagnostic checks.
3.
SPECIFICATION
MODEL:
SPBC8.V2
Supply:
230V
Output:
6/12/24V
Output Charge:
8A @ 6/12V (4A @24V)
Battery Range:
40Ah to 100Ah
Cable Length:
1.2m
IP Rating:
IP33
Dimensions:
193 x 183 x 80mm
Battery Support Mode:
13.5V DC - 8A
4.
OPERATION
WARNING! The charger does not have an on/off switch. The on and off commands are controlled by plugging the SPBC8.V2,
‰
SPBC12.V2, & SPBC16.V2 with power supply into an AC electrical wall socket only after the battery connections have been made.
4.1.
CHARGING PROCESS:
4.1.1. Fully automatic 7 stage charging system:
4.1.2. Analysis / Desulfation (Charging stage 1 illuminated) – A small voltage pulse is applied to the battery to ensure it can
effectively and safely accept a charge. Desulfation uses pulse reconditioning to gently remove any sulfation build up
on the battery plates and prevents oxidization. Stabilises electrolyte consistency and minimises the battery temperature rising by
charging, recovers battery capacity and can help extend battery life.
© Jack Sealey Limited
SPBC12.V2
230V
6/12/24V
12A @ 6/12V ( 6A @ 24V)
40Ah to 160Ah
1.2m
IP33
193 x 183 x 80mm
13.5V DC - 12A
Original Language Version
SPBC16.V2
230V
6/12/24V
16A @ 6/12V (8A @ 24V)
40Ah to 200Ah
1.2m
IP33
193 x 183 x 80mm
13.5V DC - 16A
SPBC8.V2 SPBC12.V2 SPBC16.V2 Issue 1 28/11/23
Advertisement
