Table of Contents
Advertisement
4. When the desired setting is printed out or shown on the display,
press the
I CODE]
key to enter the setting.
When using the Typestar 7
1. Press the I
CODE
I key and then the I
MODE
I key.
CODE : ASCII will appear on the display.
2. The character code setting shown on the display will alternate be-
tween LOCAL and ASCII each time the
EJ
or
E]
key is
pressed.
3. When the desired character code appears on the display, press
the
I
RETURN
I
key five times.
BAUD RATE : 1200, BIT LENGTH : 7, PARITY BIT : EVEN,
and STOP BIT : 1 will be displayed in order, followed by CR
CR/LF : CR/LF.
(It
is not necessary to set BAUD RA TE, BIT
LENGTH, PARITY BIT, or STOP BIT.)
4. The line feed method setting shown on the display will alternate
between CR and CR/LF each time the
EJ
or
E]
key is pressed.
5. When the desired setting appears on the display, press the
@_9□-f]
key.
11
Advertisement
Table of Contents
