Table of Contents
Advertisement
Using Audio/Video Dubbing
«•»**■«
Use audio/video dubbing to record audio and video from the camcorder's built-in microphone and
camcorder onto a previously recorded tape in the camcorder.
1 Hold down the small button on the CAM/
OFF / VIDEO switch while sliding the switch to
VIDEO.
2 Insert a previously recorded tape in the cam¬
corder.
'J Use the wireless remote control and press the
° PLAY button. Use the PLAY, F.FWD, and REW
buttons to find the place where you want to stop
dubbing.
A Display the linear time counter with memory
^ ("Using Memory," p45). Press the COUNTER
RESET button to set. the linear time counter to
"0:00:00mA
EJ Use the REW and PLAY buttons to find where
you wish to start dubbing.
g Place the CAM/OFF/VIDEO switch to CAM
position.
The record pause indicator "•II"
appears and the camcorder is ready to record.
7 Press and hold the A/V DUB button, then press
PLAY. This places the camcorder A/V DUB
pause mode.
"•!!" disappears replaced by
"A/VDUB II".
Q Press the Start/Stop button on the camcorder or
START/ STOP (PAUSE) on the remote control.
The audio / video dubbing starts. When the lin¬
ear time counter reaches "0:00:00M" the cam¬
corder stops automatically, recording only the
portion of the tape that you selected.
Note: If the camcorder is in AV DUB pause, or
STILL mode for more than 5 minutes, the cam¬
corder stops automaticaily to protect the tape.
Note: When the audio/video dubbed portion is
played back, noise may appear at the end of
the dubbed portion.
VM-H675LA/VM-E575LA/VM-E573LA
E53
Advertisement
Table of Contents
