Table of Contents
Advertisement
A T-shaped FM ribbon antenna is included among the
accessories. Use it in strong signal areas (near the FM
broadcast stations). For optimum FM (and especially
FM
stereo) reception
install a special outdoor FM
antenna.
There are two types of FM antenna terminals on the
СТ-600: 30092 and 7522.
lf you use an outdoor antenna, select a location as
far as possible from sources of interference (motor-
cycle ignition noise, etc.). Between the antenna and
the CT-600 use a coaxial cable with a thickness up to
C2V. Connect to one of the 75€) terminals. If the
cable has a connector on the end, use the threaded
connector
terminal
(on the far right side of the
antenna terminal
panel). If there is no connector,
strip the end of the cable so that the core lead can be
connected
to the terminal,
with
the outer shield
sheathing
bared
to make
contact
as the cable
is
installed under the clamp. Use the 75Q terminal with
the clamp (see Fig. 5).
In some
cases the outdoor
antenna wil! require a
matching
transformer
(30092
: 7542), while some
antenna do not; be sure to carefully read the antenna
owner's manual. If you cannot use a coaxial cable for
the antenna, but must use a regular feeder line (like
that for television antennas), connect it directly to
the 300€? terrninals.
ЕМ АМТ
س
ا
ل
س
س
3009 BAL
759 UMBAL
750 UNBAL
gud
LL
A
LTA
د
TYPE
E MODEL
COAXIAL
CABLE
COAXIAL
CABLE
TYPE
E MODEL
COAXIAL
Advertisement
Table of Contents
