Download Print this page

Zanussi WDT 1061/A Instructions Manual page 21

Hide thumbs Also See for WDT 1061/A:

Advertisement

Note:
Do not interrupt the drying operation
when the programme has started running.
A temporary power failure or lack of
water may erase the ongoing drying
programme. When this occurs turn off
the machine, set up again the programme
and then turn on again the machine.
Auto Dry
It is possible to programme the machine
to run automatically from the wash
programme through to the drying
programme without pausing. In this case,
the wash load must be reduced to a
maximum of 2.25 kg (5 lb) for cottons
and a maximum of 1.5 kg (31b) for
synthetics. This is possible on all
programmes except the Wool, Silk and
Delicates programmes.
Leave the tap open and the drain hose
hooked over the edge of the sink or in
the waste pipe.
Proceed as follows:
1: Load the machine
2: Select the Wash Programme
3: Depress the Auto Dry Button
4: Select the Drying Time required, using
the 0-80 minute secotr (LOW) for
synthetics and the 0-120 minute sector
(HIGH) for cottons.
After spinning, the machine will
automatically begin the drying cycle.
Depress the On/Off pushbutton and the
machine will automatically start.
Fabric Drying Times
The drying times of all fabrics will
depend on the extent to which they have
been spun as well as the fabric
characteristics. The higher the spin speed
the shorter the drying time.
To alleviate creasing, all clothes should be
removed from the drum as quickly as
possible after completion of a drying
cycle.
Important
Only laundry washed in water should be
dried in this machine. In particular, the
following fabrics should not be loaded
into the dryer:
Clothes which were dry-cleaned or
cleaned with chemical solvents;
Woollens or mixed woollens which will
shrink with heat;
Extremely delicate fabrics such as silk
and synthetic curtains;
Sponge, rubber and similar items;
Fibre glass items.
Fabrics tending to fray as, for example,
carding wool, cotton-wool or excessively
frayed carpets.
21

Advertisement

loading