Panasonic EY6812 Operating Instructions Manual page 9
Cordless rotary hammer
Hide thumbs
Also See for EY6812:
- Operating manual (12 pages) ,
- Service manual (11 pages) ,
- Service manual (11 pages)
Table of Contents
Advertisement
EYQ214
1. Plug the charger into an AC outlet.
2. Insert the battery pack firmly into
the charger.
Battery
pack
Battery
charger
• When charging, cooling fan in
the charger functions to cool
down the battery pack, and the
sound of fan can be heard. This
Is normal. If this sound cannot
be heard, it is a malfunction.
Stop charging immediately and
consult an authorized dealer.
3. During charging, the charging
lamp will light up.
When the charge is completed, an
internal electronic switch will
automatically be triggered to
prevent overcharging.
• Charging will not occur if the
battery pack is warm (for exam¬
ple, immediately after heavy-
duty operation). The orange
standby lamp will light up until
the battery becomes cool.
Charging will then begin auto¬
matically.
4. When charging is completed, the
charging lamp will start flashing
quickly.
5. When the battery pack has not
been used for a long time, the
charging lamp starts flashing
slowly to indicate protective
charging. Protective charging
takes longer to fully charge the
battery pack, than the standard
charging time. (Max. charging time
is approx. 90 minutes.)
• If a fully charged battery pack is
inserted into the charger again,
the charging lamp may tight up.
After several minutes, the charg¬
ing lamp may flash quickly to
indicate the charging is complet¬
ed.
6. If the charging lamp does not light
immediately after the charger Is
plugged in, or if after the standard
charging time the lamp does not
go off, consult an authorized
dealer.
Note:*When a cold battery (of about
5gC or less) is to be charged
in a warm room, leave the
battery in the room for at least
one hour and charge it when
it has warmed up to room
temperature. (Failing to do so
may result in less than a full
charge.)
• Cool down the charger when
charging more than two
battery packs consecutively.
• Do not insert your fingers into
contact hole, when holding
charger
or
any
other
occasions.
CAUTION:*Do not use power
source from an engine
generator.
• Do not cover vent holes
on the charger and the
battery pack.
Lamp indications of the EY0214
Charger i«
plugged into
a wall
outlet.
Ready to charge.
Now charging
Charging Is completed
Protective charging
Battery pack Is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
-9-
Advertisement
Table of Contents
