GE 400 Series Owner's Manual page 30
Hide thumbs
Also See for 400 Series:
- User manual (79 pages) ,
- Maintenance manual (28 pages) ,
- Owner's manual (72 pages)
Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting Tips ...
Problem
Oven racks are difficult to
slide
Shiny, silver-colored racks
are discolored and dull
in appearance
(on some
models)
Steam from the vent
Water remaining on oven
floor after Steam Clean
cycle
There is no steam during
the steam clean cycle
Oven will not steam clean
"F— and a number or
letter" apear or flash in the
display
My oven door glass
appears to be "tinted" or
have a "rainbow" color.
Oven door is crooked
Drawer does not slide
smoothly or drags
30
Possible Cause
The shiny, silver-colored racks were cleaned in a self-
clean cycle.
lubrication
Extension racks that need cleaning and lubrication
Self-clean, enameled racks
The shiny, silver-colored racks were left in the
oven during a self-clean cycle.
When using the ovens, it is normal to see steam
coming out of the oven vents. As the number of
racks or amount of food being cooked increases,
the amount of visible steam will increase.
This is normal.
This is normal.
Oven controls improperly set
Oven door is not closed.
You have a function error code.
The inner oven glass is coated with a heat barrier
to reflect the heat back into the oven to prevent
heat loss and keep the outer door cool while
baking.
The door is out of position.
The drawer is out of alignment
Drawer is over-loaded or load is unbalanced.
What To Do
Apply a small amount of vegetable oil to a paper towel and
wipe the edges of the oven racks with the paper towel. Do
not spray with Pam® or other lubricant sprays or use peanut
Remove racks from the oven before running self-clean.
This is normal.
Remove any remaining water with a dry cloth or sponge.
Make sure you close the door to start steam clean cycle
and do not open the door during the cycle. See the Care
Press the Cancel pad. Allow the oven to cool and then put
the oven back into operation.
Press the Cancel pad. Disconnect all power to the oven
function error code repeats again, call for service.
this tint or rainbow color.
out of position during installation. To straighten the door,
re-install the door. See the Care and Cleaning – Exterior
Surfaces – Oven Door section.
Fully extend the drawer and push it all the way in See the
Care and Cleaning – Exterior Surfaces – Storage Drawer
section.
Reduce weight. Redistribute drawer contents.
49-2001186 Rev. 0
Advertisement
Chapters
Table of Contents
