Table of Contents
Advertisement
Installing the cooker
For safety reasons, the cooker may
only be used when it has been fully
installed.
The cooker requires a sufficient
supply of cool air for efficient
operation. The required supply of
cool air must not be excessively
heated by other heat sources (e.g.
solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the interim shelf that
the cooker sits on does not touch the
wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Before installation
Ensure that there is no power to the
socket.
Please observe the wiring diagram on
the cooker.
Remove the appliance lid to connect
the single conductors of the power
cable to the connection terminals.
All H 2xxx I cookers that are combined
with an induction hob are also
equipped with a ferrite ring.
With the exception of the earth
conductor, all other single conductors
of the power cable must be drawn
through the aperture of the ferrite ring
before they are secured to the
connection terminals.
Secure the single conductors to the
respective connection terminals.
Replace the appliance lid.
Installation
71
Advertisement
Table of Contents
