Table of Contents
Advertisement
2
Installing the IP500 Series Appliance
Note
The power supply automatically configures itself to the input voltage: 100
to 130V and 200 to 240V AC.
To connect the IP500 Series appliance to a power source
1. Plug the power cord into the power plug socket on the back of the
appliance.
2. Plug the other end of the cord into a grounded power strip or wall outlet.
3. Turn on the appliance by toggling the on-off switch on the back of the
appliance to the right.
You hear the appliance fans, which run whenever the appliance is on. The
PWR LED glows green.
Connecting to the Console
The IP500 Series appliance comes with a null-modem serial cable with a
DB-9 connector. Use this cable to connect one of the following consoles to the
appliance:
A standard VT100-compatible terminal
A DOS or Windows computer running a terminal emulation program
(such as HyperTerminal)
A UNIX workstation
Note
The console port on the appliance is an EIA-232 data terminal equipment
(DTE) interface with 8 data bits, no parity, and 1 stop bit, running at
9600 bps.
30
All manuals and user guides at all-guides.com
IP500 Series Installation Guide
Advertisement
Chapters
Table of Contents
