Copyright 2006 InnoLux Tech. Corp. Ltd All Rights Reserved This manual may not, in whole or in part, be copied, Photocopied, reproduced, translated, or converted to any electronic or machine readable form without prior written permission of InnoLux Tech. Corp. Ltd. Acer P205H Service Manual...
Acer Acer –LCD-P205H Important Safety Notice Safety precautions This monitor is manufactured and tested on a ground principle that a user’s safety comes first. However, improper used or installation may cause damage to the monitor as well as to the user.
1. General: P205H series LCD monitor is designed with a wide screen 20.0” WXGA+ TFT LCD panel, LVDS interface, analog RGB signal input and DVI-D signal input.It featured with embedded universal AC power supply. This monitor can support maximum resolution up to 1600 x 900@60Hz.
Page 5
Acer Acer –LCD-P205H Temperature range : -20°C to 60°C Humidity range : 10% to 90% note 2 2.1.3 Altitude Operating 10000 ft (Ta=50, t=24h) Storage 40000 ft (Ta=30, t=24h ) Note 1: Temperature and relative humidity range must be in the area shown as the following figure due to panel limited Note 2: Altitude spec must not over panel spec.
Page 6
Acer Acer –LCD-P205H Items Condition Spec Note AC Input Voltage range Universal input full range 90~264Vac AC Input Voltage rating Universal input full range 100~240Vac AC input frequency range 90~264Vac 47~63Hz AC input frequency rating 100~240Vac 50~60Hz AC Input Current 100Vac 1.5A(max)
Page 7
Acer Acer –LCD-P205H Power On active ≤ 48W Blue blanked < 2W Yellow Power Saving blanked < 2W Yellow blanked < 2W Yellow Power Off < 1W Backlight Power Supply 3.1.4 Items Specification SEC LTM200KT01 panel Panel panel LGD LM200WD1-TLB1...
Page 8
Acer Acer –LCD-P205H Cool 9300K 0.283 ± 0.030 0.297 ± 0.030 Warm 6500K 0.313 ± 0.030 0.329 ± 0.030 User Panel While x Panel While y 3.4 Brightness uniformity The test standard conditions refer to Sec 3.4. Note (4): 25% is for Samsung panel LTM200KT01 (first source).The second source spec follow Sec 5.1.
Page 10
Acer Acer –LCD-P205H P205H DVI EA DE 5. Function Specifications 5.1 Keypad Function 6.1.1 Control buttons A. When OSD un-displays, press [AUTO] and the function menu will show on the screen; [AUTO] B. When function menu displays, press [AUTO] to perform auto-adjustment;...
Page 11
Acer Acer –LCD-P205H HOT KEY OPERATION FUNCTION DESCRIPTION e Color AUTO MENU ◄ ► POWER Press [ ], and then press [POWER] for DC FACTORY ● power on. OSD menu will be shown with “F” on MODE the left top. Select “F” for entering factory mode.
Page 12
Acer Acer –LCD-P205H OSD Timeout 10~120 Full Default Wide Mode Aspect DDC/CI Analog Source Digital EMEA NO-EMEA English English Setting Russian 繁體中文 Deutsch Deutsch Language Français Français English Español Español Italiano Italiano Dutch 简体中文 Finnish 日本語 Reset Resolution H.Freq Info V.Freq...
Page 13
Acer Acer –LCD-P205H 6. SOP of firmware upgrade ( Manufacturer of Scaler is Mstar) 6.1 Operational condition: Equipment: PC, ISP card, signal cable and power cable. ESD requirements: antistatic wrists, antistatic gloves (fingers), and connecting cable Name of ISP program: ISP_Tool_v3.7.5.exe Manufacture of FW IC :...
Page 14
Acer Acer –LCD-P205H FW software rooter Software Checksum Thirdly, select “Connect” and enter ISP MODE as in the following Figure 3. Fourthly, select “AUTO”, and keep its default value. Click “RUN” for beginning programming. There will be prompting if programming is OK.
Page 15
Acer Acer –LCD-P205H Note: if programming fails or success rate is not high, click “Config” and adjust its speed in “E2PROM DEVICE SETTING”...
Page 16
Acer Acer –LCD-P205H After connecting, AC ON, DC ON ◆Flowing chart Open ISP program Choose manufacturer and model of FW IC LOAD FW software Click Connect and enter ISP MODE Choose Config Click AUTO and RUN for and adjust beginning programming...
Acer Acer –LCD-P205H 04 Troubleshooting 1. No Power & Power LED Off No power &LED off Check prim ary Check IC802, Check circuit if short rectifier voltage C805, T801 Check F801, F802, P801, D801 Check R801, Check pin3 of IC802...
Page 52
Acer Acer –LCD-P205H 2. DC output voltage is unstable U n sta b le p o w e r C h e ck C h a n g e R 8 1 0 , C h e ck R 8 1 0 ,...
Page 53
Acer Acer –LCD-P205H 3. Backlight can’t be turned on N o ra s te r Y E S L E D G re e n ? Y E S B a c k lig h t c a n n o t b e tu rn e d o n...
Page 54
Acer Acer –LCD-P205H 4. Black Screen and backlight turn on...
Page 73
CN901 POWER LED_G LED_A 4P 1.25mm SMD Pitch=1.25mm PCB Footprint same PX193W keypad LED901 SW901 POWER InnoLux P235H/205H keypad Document Number : SIZE : APPRO BY : TITLE : CHECK BY : Keypad 2008-2-03 DATE : DRAWN BY : Rev : SHEET...
Page 74
Note: Note3 1. Shut down control for BA20550, Logic low is placed on Note1 U751 C751 C752 this terminal for shut down mode, Logic high is placed on 0.1/16V 0.1/16V LINN RINN this terminal for normal operation C753 C754 0.1/16V AL_in LINP RINP...
Page 75
CN902 CN901 POWER LED_G LED_A LED_A E-Color AUTO RIGHT/LEFT 4P 1.5mm 90° R901 MENU 8P 1.5mm 90° Pitch=1.5mm E-color AUTO MENU RIGHT LEFT InnoLux P235H/205H keypad Document Number : SIZE : APPRO BY : TITLE : CHECK BY : KEYPAD 2009-02-05 DATE : DRAWN BY :...
Acer Acer –LCD-P205H 07 Assembly and Disassembly The tool of Assembly and disassembly: 1) Electrostatic gloves 2) Electric screwdriver: the length of screwdriver top is 6±0.5cm and 15±0.5cm ; the diameter of screwdriver top is Φ5*H5mm Sequence Item Photo Procedures Description 1.Take panel out of box and place it on the...
Page 77
Acer Acer –LCD-P205H Assembly and Disassembly (continue) ASSY Assemble Place the chassis on the cushion after CHASSIS,W/O chassis and PI 701000018903R check, like the attached picture AUDIO,W board DVI,SEC,LE20T5 PCBA,P/I Assemble Insert power board into the designated BOARD,W /O chassis and PI...
Page 78
Acer Acer –LCD-P205H Assembly and Disassembly (continue) Take 5PCs M3*6 screws to fix powerboard Fix powerboard as attached picture. Take1PC M3*6 screw to fix maindboard as Fix mainboard attached picture. 1. Handle hexagonal screws and electric opener; Twist 2. Twist screw in the interface as attached hexagonal picture;...
Page 79
Acer Acer –LCD-P205H Assembly and Disassembly (continue) 1. Insert FFC cable into desiganted Insert FFC connector and use jig to insert it;; cable 2. Tear off foil to stick the cable for fix. Insert 4pcs lamp wire into the relevant...
Page 80
Acer Acer –LCD-P205H Assembly and Disassembly (continue) be sure the Put the cable in Put the cable in the position as the picture cable in the the position ASSY BACK Buckle back cover according to the Assemble back COVER,W /O...