D-Link DGS-3130 Series Hardware Installation Manual page 38

Layer 3 stackable managed switch

Hide thumbs Also See for DGS-3130 Series:

Table of Contents

DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide

1. Insert one end of the 22-pin DC power cable into the receptacle on the Switch and the other end into the

Redundant Power Supply unit.

2. Using a standard AC power cable, connect the redundant power supply to the main AC power source. A

green LED on the front of the DPS-700 will glow to indicate a successful connection.

3. Re-connect the Switch to the AC power source. The LED indicator will show that a redundant power supply is

now in operation.

4. No configuration in the Switch's firmware is needed for this installation.

NOTE: See the RPS Quick Installation Guide for more information.

CAUTION: This equipment is to be connected only to PoE networks without routing to the

outside plant.

Figure 3–13 Front view of the DPS-700

Table of Contents