Huawei DBS3900 Installation Manual page 108

Hide thumbs Also See for DBS3900:

Table of Contents

DBS3900 (Ver.B)

Installation Guide

Step 2 Route the cables by referring to

Step 3 Label the installed cables by referring to Attaching an L-Shaped Label.

Installing the FE/GE Cable

This section describes the procedure and precautions to be taken for installing an FE/GE cable.

Step 1 Connect one end of the FE/GE cable to the FE0 or FE1 port near the OUTSIDE label on the

UFLP, as shown in

Issue 06 (2011-09-15)

Figure 6-85 Installing a FE/GE surge protection transfer cable

l You must use shielded straight-through FE/GE cable.

l For details about how to connect the FE/GE cable, see Transmission Cable Connections.

l The descriptions about the installation positions and routes of the FE/GE cables in the -48 V DC cabinet

and in the APM30H are the same. For details, see

Huawei Proprietary and Confidential

6 Outdoor Scenario with AC Power Supply (BBU Installed

6.5.1 Cabling

Requirements, and then use cable ties to bind

in an APM30H)