Table of Contents
Advertisement
MEX-M72BT/N5300BT/N7300BD
3-5.
CHASSIS TOP/COVER BOTTOM BLOCK-2
Note 1: Anti-static measures are required before removing the fl exible
fl at cable (24 core) that connects the CD mechanism deck and
MAIN board, and after installing it.
Make sure to refer to "ABOUT ANTI-STATIC MEASURES
PROCESSING AT THE DETACHING/INSTALLING THE
MECHANISM DECK" on page 11 and perform anti-static
measures.
2 Solder the short-land.
Note 2: The solder of the short-land must be
removed during assembly.
Make sure to check that the flexible flat
cable (24 core) connects the MAIN board
and board of the CD mechanism deck
before removing the solder.
short-land
– Bottom view –
3 Draw the flexible flat cable (24 core)
out of the connector (CN1).
Note 3: Be sure to implement "Note 2" before
• How to install the flexible flat cable (24 core)
Note 4: When installing the flexible flat cable (24 core) to the connector (CN1)
on the CD mechanism deck, insert straight to the connector.
No slanting after insertion.
OK
Insert straight into the interior.
flexible flat cable
(24 core)
connector
37
1 Lift up the cover bottom
rear side
removing this flexible flat cable.
connector
(CN1)
terminal side
Insert only part way.
flexible flat cable
(24 core)
connector
– Bottom view –
block in the direction of
the arrow.
rear side
4 chassis top block
NG
– Bottom view –
Sony CONFIDENTIAL
For Authorized Servicer
cover bottom block
chassis top block
top side
5 cover bottom block
NG
Insert at a slant.
flexible flat cable
(24 core)
connector
– Bottom view –
SYS SET
Advertisement
Table of Contents
