Power Supply - Philips AE 3750 Instructions For Use Manual
Digital world receiver
Hide thumbs
Also See for AE 3750:
- Gebruiksaanwijzing (13 pages) ,
- Mode d'emploi (13 pages) ,
- Instructions for use manual (14 pages)
Table of Contents
Advertisement
Power supply
General
MAINS ADAPTOR
(not included)
_
You can connect the set to the MAINS, using a
mains adaptor.
• Make sure that the local voltage
corresponds to the voltage of the 9V
adaptor.
Important!
• The 2.1 mm centre pin of the 5.5 mm
adaptor plug must be set to the minus pole
©, as indicated
under the 9V DC IN
socket ©-©-©.
• Connect the mains
adaptor to the 9V DC
socket of the set and plug the mains adaptor
into the wall socket. The battery supply will
now be disconnected.
• Always disconnect the mains adaptor if you
are not using it.
Note:
Remove the batteries if you intend to
operate the set permanently on the
mains supply.
BATTERIES
(not included)
_
• Open and lift up the battery door and insert
as indicated six 1.5 volt batteries
(prefererably alkaline), type R6, UM 3 or AA.
Make sure the battery polarity is correct.
- Remove the batteries from the set if they
are exhausted or not to be used for a long
time.
- When the batteries are running low, O
will start flashing on the display. If the radio
is on, it will automatically switch off.
- Do not dispose of exhausted batteries with
your household waste. Please inquire about
how to dispose of batteries according to
local regulations.
GENERAL FEATURES_
Reset hole
Should you receive external interference e.g.
static electricity from carpets, which affects
the display and electronic functions of your
set, the RESET hole allows you to clear all data
from the set and to start up again,
• Use a bent-up paper clip to press RESET.
Lock
The LOCK button helps to prevent any of the
front panel controls from accidentally being
pressed when you are using the set (POWER
ON) or in POWER OFF position.
1. If you wish to lock the functions of your set,
press the LOCK button.
- 6 appears on the display when LOCK is
activated.
Limmiii
o o
o
n
JUUU.
2. To deactivate the LOCK function, press
LOCK again.
- fi disappears from the display.
Display light
1. Press -Q- on the top panel.
- The display will light up for about 10
seconds.
2. If you wish to switch off the light within 10
seconds, press ^ again.
3. If you wish to extend the lighting time,
press any other control on the set.
MEMORY PROTECTION_
The memory protection acts as a backup,
should there be a power failure or interruption.
When changing batteries or the power supply,
the time settings, the stored radio stations and
the last station listened to remain in the
memory for approximately 30 minutes.
ACCESSORIES
(included)
_
• SW compact wire in winder for improving
SW radio reception.
5
Advertisement
Table of Contents
