Table of Contents
Advertisement
'----C_ON_F_I_GU_R_A_T_IO_N_IN_F_O_R_M_AT_I_O_N
I~
INTRODUCTION
This appendix describes how to configure MPE to include the OfficeShare LAN/3000 link.
The MPE configuration must be modified when a LANIC card is added to the computer system. Before
configuring MPE) install the LANIC card as described in Section 2.
CONFIGURA TION DIALOG
The followIng configuration dialog deals only with configuring a LANIC card into the system. The
complete configuration dialog is contained in the
HP 3000 System Operation and Resource Management
Reference Manual, part number 32033-90005.
To begin the configuration dialog) log onto the system as MANAGER. SYS) define the output files as
shown below) and initiate a SYSDUMP as outlined in the following steps.
NOTE
Where necessary to distinguish user input from computer output) the user
input is underlined. The "Step No." in the dialog below corresponds to the
"Step Number" in the dialog contained in the
HP 3000 System Operation
and Resource Management Reference Manual, part number 32033-90005.
It
is essential that the LANIC driver) IOLANO. PUB. SYS be present when
the UPDATE or COLDSTART or RELOAD is done. You may verify that
the driver is present by typing:
:LISTF IOLANO.PUB.SYS
Define the output files and initiate SYSDUMP as follows:
:HELLO MANAGER.SYS
:FILE T;DEV=TAPE
:FILE L;DEV=LP
:SYSDUMP *T,*L
11/85
A-1
Advertisement
Table of Contents
