Table of Contents
Advertisement
MAINTENANCE
A
CAUTION
Before the cleaning, stop operation and disconnect the power supply.
Air filter
m
Clean the air filter, as it removes dust inside the room. It should be washed when
the
M
(FILTER) lamp lights. In case the air filter is full of dust, the air flow will
decrease and the cooling capacity will be reduced. Further, noise may occur. Be
sure to clean the filter following the procedure below.
Procedure
Remove the filter.
• Press the mark "PUSH" on the left and
right sides of the suction grille.
• Pull the front cover forward (Until the fixed
position).
• Slightly lift the filter and release the claws
(2 locations) at the lower part of the front
cover and remove the filter from the lower
side.
Remove dust from the filter using a vacuum-
cleaner.
If there is too much dust, use neutral
detergent. After using neutral detergent, wash
with clean water and dry in the shade.
Install the filters. (Set them with "FRONT"
mark facing front.)
Slightly lift the suction grille and close as
original state.
(Press the mark "PUSH" at the left and right
sides of the suction grille to fix it securely.)
A
CAUTION
• Do not wash with hot water at more than 40°C. The filter may shrink.
• When washing it, shake off moisture completely and dry it in the shade; do not
expose it directly to the sun. The filter may shrink.
• Do not operate the air conditioner with the filter removed. Dust may enter the air
conditioner and cause trouble.
-
16
-
Advertisement
Table of Contents
