Table of Contents
Advertisement
Available languages
Available languages
Installation of Rubber Drain Hose Adaptor
For a large port, use the drain hose as it is.
1. For a small port, insert the rubber drain hose
adaptor into the drain hose end.
2. Obtain the Rubber Drain Hose Adaptor (H)
spring clamp from the Dishwasher Installation Kit
(do not substitute).
3. Insert the drain hose adaptor into the end of the
drain hose (see Figure 14). Be sure to fully insert
the drain hose adaptor.
4. Use the clamp provided to attach the drain hose
to the house plumbing as shown in Figure 15.
Installation of Mounting Brackets
CAUTION
Before installing the supplied countertop mounting
brackets, decide which method of securing the
dishwasher into its enclosure will be used. Once the
mounting brackets are installed on the dishwasher,
removing them is difficult and will damage the mounting
brackets and the dishwasher.
The dishwasher can be secured into its enclosure in
2 ways:
NOTE: If your dishwasher opening width measures >18
in (458 mm) use the TOP OR SIDE MOUNT mounting
methods. If your dishwasher opening width measures
17.7 - 18 in (450 - 458 mm) use the ALTERNATE SIDE
MOUNT mount-ing method.
Figure 14
Figure 15
Top Mount is used for countertops made of wood
or other materials that can be easily drilled. Orient
the mounting brackets as shown in Figure 16, and
position the two small tabs on the mounting
brackets over the two slots on the dish-washer's
front corners. Push the mounting brackets down.
Side Mount is used for countertops made of
marble, granite, or other very hard materials that
cannot be easily drilled. Bend the mounting
brackets along the small holes and in the same
direction as the two small tabs. Orient the mounting
brackets as shown in Figure 17, and position the
two small tabs on the mounting brackets over the
two slots on the dishwasher's front corners. Push
the mounting brackets down firmly to insert the tabs
into the slots. Bend perforated edge down as
shown.
Alternate Side Mount for opening 17.7-18 in (450-
458 mm). Insert a side mount force distributor (Part
I) in each side as shown in Figure 18.
Figure 16
Figure 17
Figure 18
9
Advertisement
Table of Contents
