Table of Contents
Advertisement
USING AN ADDITIONAL CCP-04B PRINTER
Connect the CCP-04B to the CCP-13B as illustrated and connect
the units to appropriate ac outlets.
The method of operation is the same as described for duplication
with a single CCP-13B; the numbers in the illustration refer to the
sequence of operations.
LINE OUT
CONTROL
CCP-13B
Signal
connecting cords (supplied with the CCP-04B)
Drive contro! cable
(supplied with the
CCP-04B)
LINE IN
CONTROL
INPUT
CCP-04B
@ Turn the POWER switches ON. Allow a few seconds of build-up
time before operating the units.
@ Set the track selectors to 2CH for one side or to 4CH for both
sides duplication, as desired.
© Insert the original cassette and adjust the track level as describ-
ed before.
,
@ Insert copy cassettes.
@ If thetapes are not completely wound to the left reel, press the
REWIND button. When the tapes are rewound to the beginning, the
rewind mode will stop automatically.
@ Depress the RECORD button. The RECORD indicators will light
and the duplication will begin.
CCP-13B*
The tapes in the CCP-04B can be stopped with the CCP-13B STOP
button, and in the 4CH mode, the tapes can be rewound with the
CCP-13B
REWIND
button.
See "TYPICAL
OPERATING
CONDI-
TION".
To stop or rewind the CCP-04B tapes only, depress the respective
button of the CCP-04B.
@ When using a CCP-13B as an additional printer, do not insert a
cassette into its ORIGINAL
cassette compartment,
but set the
track selector for the ORIGINAL
compartment
according to the
position set for the original cassette in the master CCP-13B.
@ When using two additional cassette printers, note the connec-
tion order.
LINE our |
[une IN
LINE
IN
I
RL ecc ee
(or CCP-04B)
CONTROL (or CONTROL IN PUT)
LINE OUT
* Nothing should be connected to the first CCP-13B LINE IN jacks. Other-
wise, the signal of the original cassette in it cannot be duplicated.
Advertisement
Table of Contents
