Adjust The Volume - Kenwood 107VR Instruction Manual
Audio video surround receiver
Hide thumbs
Also See for 107VR:
- Instruction manual (33 pages) ,
- Instruction manual (32 pages) ,
- Instruction manual (32 pages)
Advertisement
Turn the power ON.
1O7VR [En]
ON /STANDBY
A- SPEAKERS -8
SAS
ID
SPEAKERS
| stanosy @ *ae °
fe)
a
B
Light up tne ina-cator of the des:red speaKers
INPUT SELECTDA
Play the selected source.
5 | Adjust the volume.
VOLUME CONTROL
(CY)
To decrease
To increase
volume
DOWN
uP
volume
Keys or controls to be used In this operation
8 can be switched by operating the SPEAKERS A and
B keys as described below.
For the speaker connection method:
ee
eS The sound output from SPEAKERS A and SPEAKERS
Note
A, BOFF - The speakers do not output sound. Use thrs positron when
listening sound through headphones, etc.
AON
: The speakers connected to the SPEAKERS A terminais on
the rear panel output sound.
A OFF
: The speakers connected to SPEAKERS A, center speaker
and sub-woofer do not output sound.
BON
: The speakers connected to the SPEAKERS B terminals on
the rear panel output sound.
A.B ON.
The speakers connected to the SPEAKERS A and B term
nals on the rear panel output sound simultaneously.
e When the surround mode is entered while both SPEAKERS AandB
are
ON, SPEAKERS B are turned OFF automatically
Ifthe SPEAKERS B key s pressed at this time, SPEAKERS B are turned
ON, and the surround mode is canceled.
eWhen
the surround
mode
1s entered
while SPEAKERS
B are ON,
SPEAKERS B are turned OFF automatically, SPEAKERS A are turned
ON and surround play starts.
The input sources are switched in the following order:
1 TUNER
(frequency display)
The selected source 1s
2 PHONO
displayed.
3 VIDEQ1 (TAPE 1 or MD}*!
_
~
4CD
.
7
5 VIDEO2
!
i
6 AV AUX
dL
': Switching the VIDEO? display to TAPE1 or MD display
When a KENWOOD cassette deck or MD recorder is connected in the
[SL16] system control mode, the VIDEO 1 input should be switched to
the TAPE1 or MD input with the following operation.
OSelect VIDEO1
with the INPUT SELECTOR.
@Press and hold the AUTO
key for more than 2
Note
seconds to select TAPE1
or MD.
—-~
2TAPE1
-
3 MD
1 VIDEQO1
Volume
fevel is displayed
ert)
2 mm
ot
|
vo LIk,
mo
co
e The time taken till-the volume level is displayed is variable depending
on the current operating condition.
@ Rotating the VOLUME
CONTROL
at a higher speed increases the
amount of volume change (Al VOLUME function).
eThe
sound
of input source
cannot
be listened to while TAPE
2
MONITOR
is ON.
Advertisement
