Table of Contents
Advertisement
PRESET STATIONS
@ Storing a station (on the desired waveband)
[4] Tune in the desired station (See 'SEARCH TUNING' or 'MANUAL TUNING').
[2] Press the desired preset key (1 - 6] for at least 2 seconds (until you hear a beep).
The display shows the preset number on which the station has been stored.
Note:
When storing on FM station, the AF mode (on or off) is stored on the preset.
@ Recalling a station (on the desired waveband)
[1] Briefly press the desired preset key (1 ~ 6).
-
The display shows the frequency of the selected station. For RDS stations this is followed by
the station-name.
m Preset Scan (to hear each preset station in turn for 10 seconds)
Briefly press the SCAN key. The display shows alternately:
~
'SCAN' and the waveband {for example 'FM3'}.
~
the station-name (or frequency) and the preset number.
[2] To stop the scan, briefly press the SCAN key again.
AUTO-STORE (to automatically store 6 stations on FM or MW)
This function is useful when travelling through different reception areas.
When you use Auto-Store the new stations replace any stations previously stored on the FM3
band {for FM) or the MW2 band {for MW).
= Automatically storing stations (on FM3 or MW2 only)
[1] Briefly press the AST key. The set gives a beep and then mutes.
~ The display shows 'AST'. The radio starts searching from the current frequency and stores
6 stations on the FM3 or MW2 band. When it has finished you hear a beep.
Interrupting Auto-Store: If Autostore has been accidentally activated, the Auto-store can be
aborted before the set completes the AST function. Switch the set off and then en again.
Note: Sometimes it may not be possible to find six stations. In this case, the remaining presets (for example
5 and 6} are programmed with '000'.
Advertisement
Table of Contents
