1D-1 Engine Mechanical:
Engine Mechanical
Compression Check
Check compression pressure on all 4 cylinders as
follows:
1) Warm up engine to normal operating temperature.
2) Stop engine after warming up.
NOTE
After warming up engine, place transmission
gear shift lever in "Neutral", and set parking
brake and block drive wheels.
3) Disconnect negative (–) cable at battery.
4) Disconnect ECM connectors (1) and pre-heating unit
connector (2).
2
Diagnostic Information and Procedures
S5JB0B1404001
1
I5JB0B140001-01
5) Remove all glow plugs referring to "Glow Plug
Removal and Installation: in Section 1C".
6) Connect negative (–) cable at battery.
7) Install special tools into glow plug hole.
Special tool
(A): 09912–56540
(B): 09912–57821
(C): 09918–26510
(B)
8) Disengage clutch (1) (to lighten starting load on
engine) for M/T vehicle.
(C)
(A)
I5JB0B140002-01
I4RH0A140057-01