Table of Contents
Advertisement
Available languages
Available languages
If the lawn utility vehicle is to be inoperative for a period
longer than 30 days, follow the steps below for storage.
Preparing for Storage
Battery
1.
Fully charge the battery with a 6 amp battery
charger. NEVER store battery without a full charge.
NOTE: ff a charger with 6 amp output is not available, a
lower output charger may be used for a longer period of
time. Do not charge the battery at a rate higher than 6
amps as it can damage the battery and reduce its life.
2.
When storing unit for extended periods, disconnect
battery cables and remove the battery from the unit.
3.
Keep the terminals and the top of the battery clean
and free from corrosion. Clean the battery with
baking soda or a commercial battery cleaner.
IMPORTANT:Do not allow any cleaning solution to get
inside the battery.
Engine
1.
To prevent gum from forming in fuel system or on
carburetor parts during storage, follow the
apprepriate step from those listed below:
a.
If fuel tank contains oxygenated or
reformulated gasoline (gasoline blended with
alcohol or ether), run engine until the gas
tank is dry.
b. If fuel tank contains gasoline only, run engine
until the gas tank is dry.
c.
If a gasoline additive is being added to the
gas, run engine for several minutes, after
adding, to circulate the additive through the
carburetor. Refer to page 11 for details on
additives.
2.
While the engine is stillwarm, change oil. Refer to
instructions on page 15.
3.
Remove spark plug and pour about 0.5oz. or 15mL
of engine oil into cylinder. Replace spark plug and
crank engine slowly to distribute the oil.
4.
Remove any debris or grass clippings from the
surface of the engine.
Equipment
1.
Clean entire unit thoroughly.
2:
Lubricate all pivot points, Wipe the entire machine
with an oiled rag to protect the surfaces.
Storing the Equipment
1.
Store unit in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
2.
When storing any type of power equipment in an
unventilated or metal storage shed, rustproof the
equipment. Using a light oil or silicone, coat the
equipment, especially any chains, springs,
beadngs and cables.
After Storage
The battery loses some of its charge each day when the
unit is not used. Recharge battery before returning to
service or every two months, whichever occurs first.
NOTE: If a charger is not available but the battery will
start the lawn utilib/ vehicle, the battery will be charged
by mowing for a minimum of one hour.
23
Hide quick links:
Advertisement
Table of Contents
