Output Connections - HP 654 A Series Operating Manual
Analog programmable dc power supplies
Hide thumbs
Also See for 654 A Series:
- Operating and service manual (77 pages) ,
- Operating and service manual (82 pages)
Table of Contents
Advertisement
npii
wj
|m
iHH
BH HIS
»Yd
-©
n
OUTPUT SAFETY COVER
m
+ OUTPUT BUS BAR
B
ANALOG CONNECTOR
m
OUTPUT SIGNAL GROUND
s
- OUTPUT BUS BAR
8
REAR KNOCKOUTS
■1
- LOCAL SENSE TERMINAL
9
BOTTOM KNOCKOUT
B
+ LOCAL SENSE TERMINAL
m
LOCAL SENSE JUMPERS
A
B
C
INSERT WIRES { FROM 22 AWG TO 12 AWG ).
TIGHTEN SCREWS.
INSERT SCREWDRIVER BLADE IN SLOT AND PRY OUT.
BEND ALONG JOINT AND BREAK OFF.
Figure 4-2. Series 657xA Rear Panel Connections
The connector accepts wire sizes from AWG 22 to AWG 12. The purpose of each analog pin is
described in Table 4-1.
Note
In addition to specific wiring instructions given in this chapter, it is good
engineering practice to twist and shield all signals wires to and from the
analog connector.
4-2
User Connections and Considerations
Output Connections
Advertisement
Table of Contents
