Table of Contents
Advertisement
3. Replace any panels that you removed earlier, as described on
4. If you replaced the motherboard, make sure that the new motherboard solves the problem that you are troubleshooting, and
then transfer options to the new motherboard. (see
5. If the imagePRESS Server is to be mounted on the furniture with the monitor, see the reassembly instructions that is provided
with the furniture assembly.
6. Connect the power cable to the imagePRESS Server. (see
7. Connect the imagePRESS Server to the printer (see
8. Print the Test Page and Configuration page.
on page 20
• If pages do not print, verify that the interface cables are properly connected.
• If image quality is poor, test the printer (see the service documentation that accompanies the printer).
9. Connect to the network. (see
10. Ask the site administrator to download a test job over the network.
If the job does not print, or has poor image quality, see printing problems and the Troubleshooting sections of the user
documentation.
Servicing the imagePRESS Server with furniture
This chapter describes how to remove the imagePRESS Server from the furniture in order to access internal components for
service.
For the assembly instruction on the Fiery NX Station, see the documentation provided with the Fiery NX Station kit.
■ Procedures
If the imagePRESS Server is installed in the optional furniture, you must remove it from the furniture before performing most
service procedures.
● Removing the imagePRESS Server from the furniture
1. Make sure the imagePRESS Server is powered off and all the cables are removed from the back of the imagePRESS Server.
2. Open the back door of the NX Station and remove all the cables from the connector panel of the imagePRESS Server.
3. Pull the server tray of the NX Station out of the stand.
● Replacing the imagePRESS Server in the furniture
1. Make sure that all the chassis panels are attached.
2. Lift the imagePRESS Server and place it on the server tray.
3. Slide the tray into the stand.
4. Reconnect all the cables.
"Entering Service Mode" on page
"Servicing the imagePRESS Server with furniture" on page 62
"Connecting to the printer and the network" on page
"Printing imagePRESS Server pages from the monitor, keyboard, and mouse"
"To connect imagePRESS Serverto the network" on page
imagePRESS Server installed on the furniture
"Opening the imagePRESS Server" on page
"Connecting the imagePRESS Server" on page
62
4. REPLACING PARTS
34.
47)
13)
15)
16)
Advertisement
Table of Contents
