Table of Contents
Advertisement
Available languages
Available languages
Lock Nut and Backing Flange
Your tool is equipped with a threaded
spindle for mounting ac ces sories. Always
use the supplied backing flange and quick-
clamping nut or the original lock nut (which
you can buy separately), that has the same
thread size as the spindle. Backing flange is
keyed to output shaft (Fig. 3). If you use the
original lock nut, always make sure that the
lock nut is tightened correctly with the
supplied wrench.
Disc Grinding Wheel
Assembly
TO ATTACH GRINDING WHEEL (FIG. 3)
1.Disconnect battery pack from tool.
2.Be sure that wheel guard is in place for
grinding.
3.Place backing flange and grinding wheel on
the spindle. Make sure the backing flange
locks into the base of the spindle.
4.Thread on the quick-clamping nut. While
holding the spindle lock, tighten nut using
the fold-up bar.
TO REMOVE: Reverse procedure.
WHEN USING SPIN-ON WHEELS
Follow steps 1 & 2, then thread wheel
directly onto spindle without using the
supplied flanges. Always make sure that the
spin-on wheel is tightened correctly with an
open-end wrench (not supplied).
TO REMOVE: Reverse procedure.
All parts of a spin-on wheel must be within
lip of grinding guard (Fig. 4). If spin-on
wheel is past lip of guard, do not use that
wheel as it does not fit on this grinder.
The tool will vibrate excessively and may
cause loss of control and the accessory may
burst.
Do not use accessories
that run eccentrically.
Assembly
SPINDLE
FIG. 3
TYPE 27
GRINDING
WHEEL
TYPE 27
GRINDING
WHEEL
FIG. 4
LIP OF GUARD
-15-
BACKING
FLANGE
QUICK-
CLAMPING NUT
QUICK-
CLAMPING NUT
SPIN-ON WHEEL
TYPE 27
WHEEL
GUARD
TYPE 27 SPIN-ON
GRINDING WHEEL
LOCK NUT
(not included)
SPINDLE
BACKING
FLANGE
LOCK NUT
(not included)
Advertisement
Table of Contents
