Epson Stylus Photo PX700FW Service Manual page 148
Hide thumbs
Also See for Stylus Photo PX700FW:
- Service manual (259 pages) ,
- Service manual (235 pages)
Table of Contents
Advertisement
Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
So as to make description easier, the printer in the photographs is
placed vertically in the following steps. Be careful about ink spilling
if the printer is tilted in practical operation.
Disconnect the AID cable from the connector on the SUB Board.(See
4.
4-84.)
Be careful about ink spilling from the Waste Ink Tube.
Do not damage the Rubber Seal or the Head Cleaner on the cap
with frames or other parts. (See
Remove the Ink System from the bottom of the printer.
5.
Bottom side
Groove on Base Frame
Connector on SUB Board
AID cable
Figure 4-84. Removing the Ink System (2)
DISASSEMBLY/ASSEMBLY
Fig.
Fig.
4-87.)
Ink System
Waste Ink Tube
Disassembly Procedures
https://www.manualsbooks.com
Install the Ink System as follows:
When the Carriage Lock sticks out, rotate the Combination
Gear in the direction of the arrow to lower the Carriage Lock.
Carriage Lock
Figure 4-85. Installing the Ink System (1)
Press the switch lever in the direction of the arrow and move the
Transmission Arm upward by rotating the Spur Gear to make a
room.
Switch lever
Spur Gear
Transmission Arm
Figure 4-86. Installing the Ink System (2)
Revision C
Ink System
Combination Gear
Transmission Arm
Transmission Arm
136
Confidential
Advertisement
Table of Contents
Troubleshooting
