Toro Z Master 8000 Series Operator's Manual page 41
Hide thumbs
Also See for Z Master 8000 Series:
- Operator's manual (68 pages) ,
- Setup instructions (16 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Figure 45
1. Negative (black) battery
cable
2. Wing nut
3. J-hook
Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
45).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts
(Figure
5. Slide the red terminal boot onto the positive
(red) battery post.
6. Install the clamp and secure it with the wing nuts
and J-hooks
(Figure
4. Clamp
5. Positive (red) battery cable
(Figure
45).
45).
Charging the Battery
WARNING
Charging the battery produces gases that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
g025144
temperature is below 0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug
the charger from the electrical outlet; then
disconnect the charger leads from the battery
posts
(Figure
3. Install the battery in the machine and connect
the battery cables, refer to
(page
41).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
1. Positive battery post
2. Negative battery post
41
46).
Installing the Battery
Figure 46
3. Red (+) charger lead
4. Black (-) charger lead
g000960
Advertisement
Table of Contents
