3.2.2 Mounting Control Boards
Mount control boards on slot 0 of the basic cabinet and the expansion cabinet.
The locations of slot 0 through slot 5 are described in the '3.1. Cabinet Configuration' section
of this chapter.
Control Board
MP20/MP20S
LCP
The procedure for mounting the MP20/MP20S and the LCP to each slot is as follows:
1) Check the exterior of the MP20/MP20S and the LCP for any damages.
Check the power when mounting or dismounting boards
Check if the cabinet power is off when mounting boards on slots. Inserting or
ejecting a board while the power is on may damage the board.
2) Align the MP20/MP20S to the guardrails of slot 0 of the basic cabinet, and slide the
MP20/MP20S into the slot.
© SAMSUNG Electronics Co., Ltd.
Table 3.12 Types of Control Boards
Slot 0 of the basic cabinet
Slot 0 of the expansion cabinet
Figure 3.7 Mounting the Control Board (1)
OfficeServ 7200 Installation Manual
Applicable Slot
3-11