urbanista Brisbane Plus - Bluetooth Speaker Manual

BUTTON CONTROLS

CONNECT TO DEVICE

Turn on the speaker via button and then turn on the Bluetooth on your device. Select "Urbanista Brisbane Plus". Upon successful pairing, the LED breathes white every 10 sec.
If the speaker have been connected to a device before, it will automatically go into pairing mode and connect to the device when powered on.

RESET PAIRING

Press to disconnect the current device and search for a new device. Press again to reconnect to the previous device.

BUTTON CONTROLS

POWER ON/OFF: Hold for 3 seconds.
PLAY/PAUSE: Press once.
VOLUME UP: Press once.
VOLUME DOWN: Press once.
NEXT SONG: Hold for 1 second.
PREVIOUS SONG: Hold for 1 second.
ANSWER/ HANG UP: Press once.
REJECT A CALL: Hold for 1 second.
ACTIVATE VOICE ASSISTANT: Press twice.

PAIRING TWO SPEAKERS

Turn on the speakers without being paired to any device.

Hold the on both speakers for 1 second until the LED indicators flash red and white. Upon successful pairing, you will hear a "bip" sound.

LED on main speaker will flash white, and the second speaker will flash white every 10 second.

CONNECT TO DEVICE

When the speakers are ready to be connected to a device, turn on the Bluetooth in your device and choose "Urbanista Brisbane Plus". Upon successful connection, both speakers LED lights will flash white every 10 seconds.
Main speaker will act as left channel and the second speaker will act as right channel.

DISCONNECT DUAL SPEAKER MODE

Press twice on either speaker. The main speaker will keep playing and the second will go into pairing mode.

DISCONNECT DEVICE

Press on the main speaker to disconnect the current device and search for a new one. Press again to reconnect to the same device.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download urbanista Brisbane Plus - Bluetooth Speaker Manual