This guide addresses only those items. You should use good judgment to identify potential safety hazards due to attachment of non-Lenovo features or options not covered by this inspection guide.
4. Check for cracked or bulging batteries. 5. Remove the cover. 6. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations. 7. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.
Grounding requirements Electrical grounding of the computer is required for operator safety and correct system function. Proper grounding of the electrical outlet can be verified by a certified electrician. Safety notices (multilingual translations) The safety notices in this section are provided in the following languages: •...
• Check for obvious damage to a hard disk drive. If the spindle of a hard disk drive becomes noisy, the hard disk drive might have been dropped or subject to excessive force. CRU list Table 1. Model: Lenovo IdeaPad 1 11IGL05 (Machine type: 81VT) Type ac power adapter self-service Table 2.
Chapter 4. Removing a FRU or CRU Service tools The following table lists tools for servicing Lenovo computers. Tools with a cross mark are needed for servicing the product models as described by this publication. Prepare them before you service the product.
3. Follow the correct sequence in the steps for removing a FRU, as shown in the illustrations by the numbers in square callouts. 4. When removing a FRU, move it in the direction as shown by the arrow in the illustration. 5.
Step 4. Release the cover from the hinges. Then, remove the lower case. Figure 3. Release the cover and remove the lower case Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Lower case Remove the battery pack Make sure the following FRU (or CRU) has been removed.
Page 36
Figure 5. Remove five screws and remove the battery pack Number of screws Screw specifications M2 x L4 Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Battery pack IdeaPad 1 (11", 05) and IdeaPad 1 (14", 05) Hardware Maintenance Manual...
Remove the speakers Make sure the following FRU (CRU) have been removed. “Remove the lower case” on page 28 Step 1. Disconnect the battery pack cable from the system board. Attention: Do not pull the cable. Use your fingernail to disconnect the cable. Figure 6.
Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Speakers Remove the WLAN card Make sure the following FRU (or CRU) have been removed. “Remove the lower case” on page 28 Step 1. Disconnect the battery pack cable from the system board.
Figure 9. Disconnect the wireless antenna cable, remove one screw and slide the WLAN card out of the slot Screw specifications Number of screws M2 x L2.5 Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: WLAN card Remove the coin-cell battery Make sure the following FRU (CRU) have been removed: “Remove the lower case”...
Disconnect the coin-cell battery cable from the system board. Then, remove the coin-cell battery. Figure 11. Disconnect the coin-cell battery cable from the system board and remove the coin-cell battery Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part:...
Page 41
“Remove the lower case” on page 28 Step 1. Disconnect the battery pack cable from the system board. Attention: Do not pull the cable. Use your fingernail to disconnect the cable. Figure 12. Disconnect the battery pack cable Step 2. Remove one screw.
Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Solid-state drive Remove the heat sink Make sure the following FRU (or CRU) have been removed. “Remove the lower case” on page 28 Step 1.
Page 43
Figure 16. Remove three screws and remove the heat sink Number of screws Screw specifications M2 x L2.5 Go to https://support.lenovo.com/partslookup to look up the Lenovo part number of the following replacement part: Heat sink Chapter 4 Removing a FRU or CRU...
Remove the system board Make sure the following FRU (or CRU) have been removed. “Remove the lower case” on page 28 “Remove the battery pack” on page 29 “Remove the WLAN card” on page 32 “Remove the heat sink” on page 36 Step 1.
Figure 18. Remove three screws remove the system board Screw specifications Number of screws M2 x L2.5 Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: System board Remove the audio board Make sure the following FRU (or CRU) have been removed.
Figure 19. Disconnect the battery pack cable Step 2. Disconnect the audio cable connector. Figure 20. Disconnect the audio cable connector Screw specifications Number of screws M2 x L4 Step 3. Remove two screws from the hinge and open the hinge. IdeaPad 1 (11", 05) and IdeaPad 1 (14", 05) Hardware Maintenance Manual...
Figure 22. Remove one screw and remove the audio board Screw specifications Number of screws M2 x L2 Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Audio board Chapter 4 Removing a FRU or CRU...
Remove the touchpad Make sure the following FRU (or CRU) have been removed. “Remove the lower case” on page 28 “Remove the battery pack” on page 29 “Remove the system board” on page 38 Step 1. Disconnect the touchpad cable. Then, remove three screws. Figure 23.
Figure 24. Remove the touchpad out of the system board Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Touchpad Remove the upper case (with keyboard) Make sure the following FRUs (CRUs) have been removed.
Page 50
Figure 25. Disconnect the battery pack cable Step 2. Disconnect the cables from the system board. Figure 26. Disconnect the cables from the system board Step 3. Remove four screws. Then, open the hinges. IdeaPad 1 (11", 05) and IdeaPad 1 (14", 05) Hardware Maintenance Manual...
Page 51
Slowly and carefully lift up the upper case. Figure 28. Slowly and carefully lift up the upper case Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Upper case (with keyboard) Chapter 4 Removing a FRU or CRU...
Note: The lower side of the LCD bezel is fixed to the LCD panel with adhesive tape. Detach with care. Figure 29. Pull the inner sides of the LCD bezel Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup parts: LCD bezel Remove the hinge cover Make sure the following FRUs (or CRUs) have been removed.
Figure 30. Remove the hinge cover Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Hinge cover Remove the hinges Make sure the following FRU (or CRU) have been removed. “Remove the lower case” on page 28 “Remove the upper case (with keyboard)”...
Screw specifications Number of screws M2 x L2 M2 x L2.5 Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Hinges Remove the LCD panel Make sure the following FRU (or CRU) have been removed.
Page 55
Figure 32. Pull the removable tapes Step 2. Carefully rotate the LCD panel so that the rear side of LCD panel is facing up. Attention: LCD panel is connected by a cable on the back side. Rotate panel carefully. Figure 33. Rotate the LCD panel Step 3.
Figure 34. Disconnect the LCD cable and remove the LCD panel Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement parts: LCD panel Remove the camera Make sure the following FRU (or CRU) have been removed.
Page 57
Figure 35. Disconnect the camera cable and remove the camera Go to to look up the Lenovo part number of the following replacement https://support.lenovo.com/partslookup part: Camera Chapter 4 Removing a FRU or CRU...