Checking The Hydraulic Lines And Hoses - Toro Greensmaster 3150 Operator's Manual
2-wheel drive traction unit
Hide thumbs
Also See for Greensmaster 3150:
- Service manual (278 pages) ,
- Operator's manual (44 pages) ,
- Installation instructions (4 pages)
Table of Contents
Advertisement
Note:
Make a close visual inspection of the
hydraulic components. Inspect them for leaks,
loose fasteners, missing parts, or improperly
routed lines. Make any necessary corrections.
Changing the Hydraulic Fluid and
Filter
Service Interval: Every 800 hours—If you are
not using the recommended
hydraulic fluid or have ever filled
the reservoir with an alternative
fluid, change the hydraulic fluid,
filter, and tank breather.
Every 1,000 hours—If you are using the
recommended hydraulic fluid, change the
hydraulic-fluid filter.
Every 2,000 hours—If you are using the
recommended hydraulic fluid, change the
hydraulic fluid.
Hydraulic Fluid Capacity: 25.7 L (6.8 US gallons)
If the fluid becomes contaminated, have your
authorized Toro distributor flush the system.
Contaminated fluid looks milky or black when
compared to clean fluid.
1.
Clean the area around the filter mounting area
(Figure
56). Place a drain pan under the filter
and remove the filter.
1. Hydraulic-fluid filter
Note:
If you will not be draining the fluid,
disconnect and plug the hydraulic line going to
the filter.
2.
Fill the replacement filter with the appropriate
hydraulic fluid, lubricate the sealing gasket, and
hand turn it until the gasket contacts the filter
head. Then tighten it 3/4 turn further.
Figure 56
3.
Fill the hydraulic reservoir with hydraulic fluid;
refer to
Hydraulic Fluid Specifications (page 41)
and
Checking the Hydraulic-Fluid Level (page
42).
4.
Start the machine and run it at idle for 3 to 5
minutes to circulate the fluid and remove any air
trapped in the system. Shut off the engine and
check the fluid level.
5.
Dispose of the fluid and filter properly.
Checking the Hydraulic
Lines and Hoses
Check the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating.
g005518
43
Advertisement
Table of Contents
